Specify the climate first, the installation format second, and the brightness third. A screen that is correctly cooled will outlast one that is merely brighter.
Four installation formats
A wall-mounted outdoor display is bolted to a facade, a pillar or a covered wall. It is the most common format and the easiest to protect, because the enclosure can vent through the back of the mounting structure.
A floor-standing totem stands on the ground and is usually double-sided or single-sided vertical. It suits plazas, forecourts, bus shelters and building entrances, and it needs a service door that a technician can open without closing the site.
A reading board is the horizontal newspaper format used in public squares and transit areas, usually at seated or standing reading height with a protective lip.
An embedded or pillar-mounted configuration is built into architecture, which looks the best and is the least forgiving of thermal mistakes, because the enclosure is constrained by the structure around it. Our outdoor range documents all four formats from 15.6 to 98 inches.
Ingress protection: what IP65 really means
IP65 means dust-tight and protected against water jets from a nozzle at low pressure. IP66 adds protection against stronger jets, such as a hose directed at the enclosure.
Neither rating tells you anything about condensation, salt corrosion or heat. A sealed enclosure in a humid climate will collect moisture inside as the air contracts at night, and the water will sit on the electronics. That is why serious outdoor enclosures use a filtered air path, desiccant or a controlled internal airflow rather than simply sealing the box.

Thermal strategy by climate
In a temperate climate, filtered fans and a smart controller are usually sufficient. The fan runs when the internal temperature exceeds a threshold, and the same controller can switch on a heater in winter to keep the panel above its minimum operating temperature.
In a hot climate with direct sun, air cooling is often not enough. The internal air temperature can exceed the ambient temperature by 15 to 25 degrees, which pushes the panel beyond its rated range. For large high-brightness panels in these locations, an air-conditioned enclosure is the reliable answer.
For a coastal site, add salt to the calculation. Specify stainless fixings, a marine-grade coating and a shorter inspection interval. Salt spray accelerates corrosion on hinges, screws and vent grilles long before it affects the panel itself.
지정하기 전에 당사에 문의하십시오.
실행하려는 공간이나 위치, 콘텐츠를 보내주세요. 우리 엔지니어들이 이를 검토한 후 실용적인 권장 사항을 제시해 드릴 것입니다. 평가 비용은 무료입니다.
Brightness and glass
An outdoor screen facing daylight needs significantly more brightness than an indoor one, because the viewer's eye is adapted to the sky. A north-facing covered location may be readable at 1,500 nits; a south-facing unshaded position in a sunny climate may need 3,000 nits or more.
If the screen is behind glass, the glass does most of the damage. Reflections of the sky and of the viewer are superimposed on the image, and no amount of panel brightness removes them. Anti-reflective coated glass, a slight tilt and a recessed mounting position are the practical remedies.
Power, network and service access
Plan the power supply for the peak load, not the average, and allow for a heater in cold climates and an air conditioner in hot ones. Those two devices can draw more than the display itself.
Network is the other frequent oversight. If the site has no wired connection, specify a 4G or 5G router inside the enclosure and confirm the antenna can see the sky from inside a metal box.
Service access determines whether the screen is repaired in a day or a month. Specify what the technician needs: a door with a lock, a shelf for tools, and enough clearance to remove a panel without closing a pedestrian route.
Content and legibility outdoors
Outdoor legibility is a design problem as much as a hardware one. The viewer is moving, the screen may be several metres away and the ambient light is high. Use large type, few colours, and strong contrast.
Plan for night. A screen that is correctly bright at noon will be painfully bright at midnight, so specify a light sensor and schedule the brightness curve. This also saves power and extends panel life.
A pre-purchase checklist
Record the maximum and minimum air temperature, the sun exposure hours, the distance from the sea if the site is coastal, and the nearest viewer distance. Confirm whether the location is covered by a roof or exposed to wind-driven rain. Measure the available depth for the enclosure, including the service clearance.
When you send those details to a supplier, you should receive a specific cooling recommendation rather than a generic one. If a quotation does not mention the thermal strategy, ask for it in writing before you order. Our engineers can prepare that assessment for your site through the 를 통해 치수와 용도를 보내주십시오. 연락처 페이지.
구매자가 우리에게 묻는 질문
우리 엔지니어들이 이 주제에 대해 가장 자주 답변하는 질문은 다음과 같습니다. 당신의 것이 여기에 없다면, 우리에게 보내주세요 그러면 우리가 직접 답변해 드리겠습니다.
Is IP65 enough for an outdoor screen?
IP65 covers dust and water jets but says nothing about condensation, salt or heat. A sealed enclosure in a humid climate will collect moisture internally. Look for a filtered air path or a controlled internal airflow.
Do we need air conditioning in a hot climate?
For large high-brightness panels in direct sun, usually yes. Internal air can run 15 to 25 degrees above ambient, which pushes the panel beyond its rated operating range. For smaller screens in shaded locations, smart fans and a heater are often sufficient.
How bright does an outdoor screen need to be?
A covered north-facing position may read well at 1,500 nits. A south-facing unshaded position in a sunny climate often needs 3,000 nits or more. The viewer's eye adapts to the sky, so the requirement is higher than it first appears.
What is the most common outdoor installation mistake?
Forgetting service access. If a technician cannot reach the player, the power supply and the panel without closing the site or hiring a lift, faults stay unfixed. Design the access route at the same time as the enclosure.
Send us your site conditions
Tell us the location, the sun exposure and the climate. We will recommend the enclosure, cooling method and brightness for that specific position.

